SHS-10 031914
MAINTENANCE AND LUBRICATION
The PowerMax4000
TM
Knife Honing system
requires very little maintenance.
THINGS TO CHECK:
1. Check the condition of the hone stone every
time you hone a Knife and perform
lubrication.
2. Periodically check that the honing
mechanism is tight and the slide bushings
on the carriage have minimum free play.
(Illustration 22)
3. Check the two cam followers for smooth
operation and minimum free play.
4. Check the Deburr Assembly bearings for
smooth operation and minimum end play.
5. Check the bearings on the Hone Assembly
for smooth operation and minimum end
play. (Illustration 23)
HONE STONE
BEARINGS
ILLUSTRATION 22
CAM
FOLLOWER
CAM
FOLLOWER
SLIDE
BUSHINGS
ILLUSTRATION 23
DEBURR
PAD
BEARINGS
To Next Page
Loading...