STEP 15 DISASSEMBLE THE DYNAMIC
SCALE CONVEYORS
1. Use a 1/4 inch wrench and turn the
jackscrew towards the front of the
conveyor to unlock the mounting studs.
(Illustration 41)
2. Lift the rear of the conveyor to remove
the mounting studs out of the slots on
the mounting brackets. (Illustration 42)
3. Unhook the drive belt from the drive
pulley and slide the drive bushings out
of the mounting brackets.
(Illustration 43 and 44)
8-14 031914
ILLUSTRATION 41
LOOSEN LOCKING NUT
ILLUSTRATION 44
SLOTS
DRIVE PULLEY
BELTS
ILLUSTRATION 42
MOUNTING STUDS
MOUNTING
BRACKET SLOTS
ILLUSTRATION 43
DRIVE
BELT
DRIVE PULLEY
MOUNTING
BRACKETS
To Next Page
Loading...