MACHINE ADJUSTMENTS
The Machine Adjustments are necessary to
operate and fine-tune the Slicer during production.
These adjustments are accessed on the “Run”
screen and on the “Adjustments” screen.
(Illustration 17 and 18) The “Run” screen displays
the basic adjustments necessary to operate the
Slicer. The “Run” screen is accessed by touching
the “Run” button on the “Home” screen. The
“Adjustments” screen displays the adjustments
necessary to fine-tune the Slicer. The
“Adjustments” screen is accessed by touching the
“Adjustments” button on the “Run” screen.
Most of the adjustments can also be
pre-programmed in the Product Codes to save
time when the same product is run again.
(Illustration 19) Some of the adjustments can only
be adjusted in the Product Code Parameters.
Refer to the “Adjusting and Creating Product
Codes” section for more information on changing
these Product Code Parameter settings.
031914 6-7
ILLUSTRATION 17
“RUN” SCREEN
ILLUSTRATION 18
“ADJUSTMENTS” SCREEN
ILLUSTRATION 19
“PRODUCT CODE SELECTION” SCREEN
To Next Page
Loading...