Understanding the Machine Menus
161
Tools
9
* : [HTTP-SSL/TLS] is available only when a certificate is created using CentreWare Internet Services. For information on creating
a certificate, refer to the online Help of CentreWare Internet Services.
Note • WSD stands for Web Services on Devices.
Advanced Settings
Purpose:
To specify advanced network settings.
z
IP Filter
Note • IP Filter feature is available only when [Protocols] is set to [LPD] or [Port9100].
Purpose:
To block data received from certain IP addresses through the network. You can set up to
five IP addresses. The change becomes effective after the machine is turned off and then
on again.
Values:
z
802.1x
Note • 802.1x feature is available only when the machine is connected using LAN cable and the 802.1x
authentication is enabled using CentreWare Internet Services. For information on setting 802.1x,
refer to the online Help of the CentreWare Internet Services.
WSD Scan Disable Disables WSD scan.
Enable Enables WSD scan.
SNMP UDP Disable Disables the Simple Network Management
Protocol (SNMP) UDP port.
Enable Enables the SNMP UDP port.
StatusMessenger Disable Disables the Status Messenger feature.
Enable Enables the Status Messenger feature.
InternetServices Disable Disables an access to CentreWare Internet
Services embedded in the machine.
Enable Enables an access to CentreWare Internet
Services embedded in the machine.
Bonjour (mDNS) Disable Disables Bonjour (mDNS).
Enable Enables Bonjour (mDNS).
Telnet Disable Disables Telnet.
Enable Enables Telnet.
Update Address Book Disable Disables Update Address Book.
Enable Enables Update Address Book.
HTTP-SSL/TLS
*
Disable Disables HTTP-SSL/TLS.
Enable Enables HTTP-SSL/TLS.
n (n is 1-5) IP Address Sets the IP address for Filter n.
Subnet Mask Sets the address mask for Filter n.
Mode Not Active Disables the IP Filter feature for Filter n.
Accept Accepts an access from the specified IP
address.
Reject Rejects an access from the specified IP address.