U41840-J-Z125-7-76 125
Remote Management
The ETERNUS CS800 system utilizes a Web-based interface which allows you to configure
and manage the system via Web pages from a remote workstation on the same network (a
Command Line Interface is also available, see the ETERNUS CS800 S5 Command Line
Interface Guide). This chapter gives you an overview about the ETERNUS CS800 Web
interface, how to access it and information about the Home page. The Web pages are
described in the subsequent chapters as follows:
● Chapter "Configuration Wizards" on page 137 allows you to set up the ETERNUS
CS800 using guided procedures.
● Chapter "Home Page" on page 177 allows you to view important system information at
a glance.
● Chapter "Replication" on page 341 allows you to manage data replication activities.
● Chapter "Status" on page 389 allows you to view the status of the hardware compo-
nents and system performance.
● Chapter "Alerts" on page 419 allows you to view administration alerts and resolve
service tickets.
● Chapter "Configuration" on page 187 allows you to configure storage presentation, data
replication, and system settings.
● Chapter "Utilities" on page 429 allows you to run diagnostic tools and maintain the
system.
Accessing Remote Management
Access the remote management console using a Web browser on a workstation that is on
the same network as the ETERNUS CS800.
See the following sections for more information about accessing ETERNUS CS800 remote
management:
● "Supported Browsers"
● "Logging On to the ETERNUS CS800"
● "Logging Off of the ETERNUS CS800"
To Next Page
Loading...
