Replication Configuration Configuration
238 U41840-J-Z125-7-76
To enable system replication throttling:
1. Under Target systems, click the box next to Throttling.
The Replication Throttle window displays (see Figure 149).
Figure 149: System Throttling
2. In the drop-down box, select the units you want to use to specify the constant throttle
(KB/s or MB/s). To disable system throttling clear the Enable system throttling check
box.
3. In the box, enter the maximum allowed bandwidth. The lowest value you can set is 32
KB/s. The highest value you can set is 125 MB/s.
4. Click Apply.
V
CAUTION!
Do not set the maximum allowed bandwidth to a value that is lower than necessary.
If the maximum allowed bandwidth is set to the lowest value, large replication jobs
may fail.
Source System List
The Source System list displays the following information for each source system:
● Source - The IP address of the source system that is allowed to send data to the
ETERNUS CS800.
● Actual Data Received - The amount of data actually received over the network during
replication or failback.
To Next Page
Loading...
