Replication Send Replication
354 U41840-J-Z125-7-76
You should perform a synchronization in any of the following situations:
● When Directory/File or Cartridge Based Replication is first enabled for a share or
partition.
● If a Directory/File or Cartridge Based Replication job fails.
● If Directory/File or Cartridge Based Replication is disabled for a time and then is re-
enabled.
I
Even when replication is paused, the system continues to queue Directory/File or
Cartridge Based Replication operations. Each time an operation is queued, the
system logs an administration alert that reports the total number of queued
Directory/File or Cartridge Based Replication requests.
I
If a synchronization fails, make sure the target share or partition is unlocked (see
"Configuring a Target Share for Directory/File Based Replication" on page 368 or
"Configuring a Target Partition for Cartridge Based Replication" on page 381).
To synchronize a share or partition:
1. Select the share or partition to synchronize.
If multiple targets are configured, click the arrow next to the share or partition to display
all targets, and then select the desired target.
2. Click Synchronize Now.
The status of the synchronization job displays in the Job Status column.
To cancel the synchronization job, select the share or partition and click Abort.
Directory/File or Cartridge Based Replication Queue
The Directory/File or Cartridge Based Replication Queue displays replication statistics for
shares or partitions that are configured for Directory/File or Cartridge Based Replication
(see "Configuring Directory/File or Cartridge Based Replication" on page 351).
To view the Directory/File or Cartridge Based Replication Queue:
1. Select a share or partition that is configured for Directory/File or Cartridge Based Repli-
cation.
If multiple targets are configured, click the arrow next to the share or partition to display
all targets, and then select the desired target.
To Next Page
Loading...
