Running the Getting Started Wizard Initial Configuration, Connecting with the Network
122 U41840-J-Z125-7-76
Date & Time
The Date & Time page allows you to set the system date and time of the ETERNUS CS800
(see Figure 77).
Figure 77: Date & Time Page
To set the system date and time:
1. Select one of the following options:
● Network Time Protocol (NTP) Server - (Recommended) Select this option to
synchronize the ETERNUS CS800 with an NTP timeserver or pool.
● Manual Date & Time Settings - Select this option to manually set the system date
and time.
Specify the New System Date by clicking the calendar icon. Specify the New
System Time using the drop-down boxes.
2. In the Timezone drop-down box, select the time zone where the ETERNUS CS800 is
located.
3. Next to Time Format, select the format to use when displaying times (24 hours or 12
hours).
4. Click Apply.
To Next Page
Loading...
