Fujitsu ETERNUS CS800 S5 - Receive VTL; Received Snapshots

Replication Receive VTL
U41840-J-Z125-7-76 371
Receive VTL
The Receive VTL page allows you to manage incoming replication activity for VTL parti-
tions. You can recover a replicated partition on the target system if the source system is
unavailable. Once the source system becomes available, you can failback the partition to
make it available on the source system again.
I
Before you can receive replicated partitions, you must specify one or more
replication sources (see "Adding a Replication Source" on page 239).
To access the Receive VTL page, click the Replication menu, and then click the
Receive > VTL tab.
Use the Receive VTL page to perform the following tasks:
● View received snapshots and recover, failback, or delete snapshots (see "Received
Snapshots" on page 371).
● Manage recovery jobs (see "Recovery Jobs" on page 377).
● Manage failback jobs (see "Failback Jobs" on page 378).
● Manage partitions configured for Cartridge Based Replication (see "Cartridge Based"
on page 380).
Received Snapshots
The Received Snapshots page allows you to view and work with received snapshots.
When a replicated VTL partition is received from a source system, it is saved as a snapshot.
The snapshot contains all of the data necessary to fully recover or failback the partition to
the point in time when the snapshot was saved.
To access the Received Snapshots page, on the Receive VTL page, click the Received
Snapshots tab (see Figure 225).