410 U41840-J-Z125-7-76
● Click Hide I/E Slots or Show I/E Slots to hide or show the virtual I/E slots in the VTL
(see "Storage and I/E Slots" on page 410).
Tape Drives
The Tape Drives section displays information about virtual tape drives in the VTL:
● If a cartridge is mounted in the tape drive, the barcode of the cartridge displays beneath
the drive.
● Click a tape drive to view detailed information about the drive.
Storage and I/E Slots
The Storage Slots and I/E Slots sections displays information about the virtual cartridges
located in the storage and I/E slots:
● The following information is displayed for each cartridge:
● Slot - The slot where the cartridge is located.
● Barcode - The barcode of the cartridge.
● WP - The write protect status of the cartridge.
● Capacity - The capacity of the cartridge.
● Used - The amount of space on the cartridge currently used to store data.
● Used Percent - The amount of currently used space on the cartridge expressed as
a percentage of the total capacity ([Used / Capacity] x 100).
V
CAUTION!
The Used (%) value is not updated while the media is mounted. Because of this,
the displayed Used (%) value may be different from the real value for mounted
media.
● Click a cartridge to view detailed information about the cartridge.
● When the storage system is degraded, all tape cartridges are shown in a degraded
state.
● When the storage system has failed or is inaccessible due to failure, all tape cartridges
are shown as unavailable.
Logical View
Use the Logical View page to view information about the virtual (logical) components in a
VTL partition. You can also view information about used space in the partition.
To Next Page
Loading...
