Fujitsu ETERNUS CS800 S5 - Replicating a Share or Partition; Synchronizing a Share or Partition

Replication Replication Send
U41840-J-Z125-7-76 353
6. Select the check box for each replication target you want to replicate the share or
partition to. When the share or partition is replicated, its data will be sent to all selected
targets.
7. Click Apply.
I
After you configure a share or partition for Directory/File or Cartridge Based
Replication, you should periodically synchronize it to keep it in sync with the
target share or partition (see "Synchronizing a Share or Partition" on page 353).
Replicating a Share or Partition
Replicate a NAS share or VTL partition to send a snapshot of the share or partition to the
target systems. A snapshot is required to recover the data on the targets at a later time. If
you have not configured a replication schedule for a share or partition, replication only
occurs when you manually initiate it (see "Scheduling a Share or Partition For Replication"
on page 356).
V
CAUTION!
Do not replicate a partition containing media in an Exported state.
To replicate a share or partition:
1. Select the share or partition to replicate.
If multiple targets are configured, click the arrow next to the share or partition to display
all targets, and then select the desired target.
2. Click Replicate Now.
The status of the replication job displays in the Job Status column.
To cancel the replication job, select the share or partition and click Abort.
Synchronizing a Share or Partition
Synchronize a NAS share or VTL partition to synchronize its contents with the corre-
sponding share or partition on the target systems. To synchronize a share or partition, it
must be configured for Directory/File or Cartridge Based Replication (see "Directory/File or
Cartridge Based Replication" on page 342).
Synchronizing a share or partition ensures that the contents of the source share or partition
are the same as the target share or partition. The synchronization verifies that the same
files or cartridges exist in both locations, and that no additional files or cartridges exist in
either location