Fujitsu ETERNUS CS800 S5 - ETERNUS CS800 S4;S5 Hardware; Server PRIMERGY RX300 S7;S8

ETERNUS CS800 S4/S5 Hardware Removal and Replacement Procedures for CRUs
504 U41840-J-Z125-7-76
ETERNUS CS800 S4/S5 Hardware
Server PRIMERGY RX300 S7/S8
Replacing PSU modules
1. Removing the defective PSU module
Figure 290: Removing the PSU
● Press in on the green locking latch (1).
● Fold up the handle on the PSU module (2).
● While keeping the green locking latch pressed, pull the PSU module out of its slot
(3).
2. Installing the new PSU module