Replication Configuration Configuration
234 U41840-J-Z125-7-76
● To show or hide a column, click a column heading, and then click Columns. Select the
check box to show a column, or clear the check box to hide a column.
I
The statistics in the Target system list are for each target system rather than a
cumulative total for all targets as is displayed on the Home page.
Adding a Replication Target
Add a replication target to configure the ETERNUS CS800 to send replicated data to that
target. You can add up to two targets. After you add a target, you can enable replication to
that target for a NAS share or VTL partition. When replication is enabled for a share or
partition, replicated data is sent to the target system during scheduled or manual replication.
I
For more information about enabling and scheduling replication for a share or
partition, see "Replication Send" on page 348.
To add a replication target:
1. Under Target systems, click Add.
The Add Target Host window displays (see Figure 147).
Figure 147: Add Target Host
2. In the Target Hostname or IP box, enter the hostname or IP address of the system that
will receive the replicated data.
I
When entering IP addresses, never use an address that is in a reserved IP
address range. To see a list of reserved IP address ranges, click the quick tip
icon [?] located near the IP address field.
I
To use hostname format, you must specify at least one DNS IP address on the
"Network" on page 286).
To Next Page
Loading...
