Handling Instructions for the Rack Installing the Rack
92 U41840-J-Z125-7-76
● Hold the slider by the handle and pull it out as far as it will go.
● Screw out the leveling feet using a 6 mm Allen key (or manually by turning the
hexagonal disc) until they are pressing against the floor.
V
CAUTION!
Do not close the rack door when the tilting protection is extracted, as the door may
be damaged.
Sliding in the tilting protection
V
CAUTION!
Before you slide in the tilting protection, screw the leveling feet back up into their
original position.
● Follow the procedure described under “Extracting the tilting protection” in reverse order.
Connecting the Power Cable
Connect the rack’s socket strip to the inhouse supply network.
To Next Page
Loading...
