Installing the Rack Handling Instructions for the Rack
U41840-J-Z125-7-76 91
Installing the tilting protection at the rear
● At the rear, the tilting protection is attached with a fixing plate.
● Attach the fixing plate to the slider with two supplied M6 x10 mm countersunk screws
(1)
.
Torque: 5.2 Nm
● Lift the tilting protection slightly so that the screw holes align with the lozenge nuts.
● Attach the tilting protection to the rear of the rack with two supplied M6x10 mm
countersunk screws (2).
Torque: 5.2 Nm
Using the tilting protection
Extracting the tilting protection
To Next Page
Loading...
