Replication Configuration Configuration
232 U41840-J-Z125-7-76
Replication Configuration
The Replication Configuration page allows you to configure and manage replication
targets and allowed replication sources on the ETERNUS CS800. A source
sends repli-
cated data to 1 or 2 targets, and a target
receives replicated data from up to 10 sources.
An ETERNUS CS800 can act as both a source and a target.
I
For more information about data replication, or to perform data replication, see
"Replication" on page 341.
I
If the ETERNUS CS800 is configured as a source and replication is performed
across a public network, with the source and target located behind NAT-enabled
routers, you must specify a NAT IP address for the ETERNUS CS800 on the
Network page (see "Configuring Interface IP Addresses" on page 292).
To access the Replication Configuration page, click the Configuration menu, and then
click the Replication tab (see Figure 146).
Figure 146: Replication Configuration Page
Use the Replication Configuration page to perform the following tasks:
● View information about configured replication target systems (see "Target Systems List"
on page 233).
● Add, edit, or delete a replication target (see "Adding a Replication Target" on page 234,
"Editing a Replication Target" on page 235, or "Deleting a Replication Target" on
page 237).
To Next Page
Loading...
