Performing Data Replication Replication
344 U41840-J-Z125-7-76
Performing Data Replication
The Replication page allows you to set up replication for NAS shares or VTL partitions and
to replicate and recover data.
To access the Replication page, click the Replication menu.
The Replication page contains the following tabs:
● "Replication Send"
● "Receive NAS"
● "Receive VTL"
● "Actions"
● "Reports"
Use the ETERNUS CS800 data replication features to perform the following tasks:
● Replicate all data on a share or partition to another system where it can be recovered
at a later time (see "Task Overview: Setting Up and Performing Replication" on
page 344).
● Automatically replicate directories and files or cartridges to another system where they
are immediately available (see "Task Overview: Setting Up and Performing
Directory/File or Cartridge Based Replication" on page 345).
● Recover data from a lost or damaged share or partition (see "Task Overview: Recov-
ering a Replicated Share or Partition" on page 346).
● Restore a lost or damaged share or partition back to its original location (see "Task
Overview: Performing a Share or Partition Failback" on page 347).
I
The Replication wizard provides guided assistance for configuring data replication
(see "Configuration Wizards" on page 137).
Task Overview: Setting Up and Performing Replication
To replicate all data on a NAS share or VTL partition from a source system to a target
system:
1. On the target system, add the source system to the list of allowed replication sources
(see "Adding a Replication Source" on page 239).
2. On the source system, specify the target system that will receive replicated data (see
"Adding a Replication Target" on page 234).
To Next Page
Loading...
