Configuration Notifications
U41840-J-Z125-7-76 331
Figure 205: SNMP Test Page
To send a test SNMP trap, select a destination in the list and click Send. If the destination
does not receive the SNMP trap, make sure that the destination IP address is correct (see
"Editing a Destination" on page 324). Also make sure that the community information is
correct (see "Community" on page 325).
AIS Connect
AIS (Advanced Infrastructure Solutions) Connect has the following functions:
● Call-home - Provides system monitoring: Service tickets which indicate hardware
failures are automatically sent to the Fujitsu Service Centre.
● Dial-in - Provides remote access: Allows Fujitsu support specialists to remotely connect
to the system. Remote access is only possible if it has been enabled on the ETERNUS
CS800 system.
The setup of AISConnect consists of two tasks:
● Configuring and enabling the AISConnect service on the ETERNUS CS800 system,
which is described below.
● Registering the ETERNUS CS800 system with the Fujitsu Service Centre.
To Next Page
Loading...
