Hardware Description and Basic Operations Server
U41840-J-Z125-7-76 53
Table 4: Indicators on the connection panel
I
Note on the onboard LAN controller
The system board is equipped with a Gigabit Ethernet Controller that supports
transfer rates of 10 Mbit/s, 100 Mbit/s and 1 Gbit/s.
Connecting the server to the mains
The server is equipped with two hot-plug power supply units. If one power supply unit is
defective, the other then guarantees unimpaired operation. Each hot-plug power supply unit
can be replaced during operation
V
CAUTION!
The server is automatically set to a mains voltage in the range 100 V - 240 V. You
may only operate the server if its rated voltage range corresponds to the local mains
voltage.
Indicator Status Description
1 LAN
link/transfer
green on LAN connection established
off no LAN connection
green flashing data transfer in progress
2 LAN speed yellow on traffic a transfer rate of 1 Gbit/s
green on traffic a transfer rate of 100 Mbit/s
green flashing traffic a transfer rate of 10 Mbit/s
3 Global error
indicator
off no critical event (non CSS
component)
orange on prefailure detected (non CSS
component)
orange flashing non CSS component failure
CSS
indicator
off no critical event (CSS component)
yellow on prefailure detected (CSS
component)
yellow flashing CSS component failure
ID indicator blue on server has been highlighted using
ServerView Operations Manager or
the ID button on the front panel for
easy identification
To Next Page
Loading...
