Server Hardware Description and Basic Operations
54 U41840-J-Z125-7-76
● Connect the power cord with the insulated connector to the power supply unit of the
server, and plug the power plug into a grounded outlet on the mains socket strip on the
rack (see Technical Manual of the rack).
I
A phase redundancy in the power supply of the server can be set up if each of the
power supply units is either connected to two different phases or to two separate
circuits of the internal power supply network.
Using the cable clamp
You can secure the power cords in a cable clamp to ensure that the insulated connectors
cannot be disconnected from the server accidentally.
Figure 11: Cable clamp
● Thread the power cord through the cable clamp (1).
● Pull the cable clamp up (2).
● Press the cable clamp down until it engages to secure the cable (3).
To Next Page
Loading...
