Configuration Replication Configuration
U41840-J-Z125-7-76 233
● Pause or resume replication to a target (see "Pausing or Resuming Replication to a
Target" on page 237).
● Configure a constant replication throttle (see "Enabling System Throttling" on
page 237).
● View information about allowed replication source systems (see "Source System List"
on page 238).
● Add or delete an allowed replication source (see "Adding a Replication Source" on
page 239 or "Deleting a Replication Source" on page 240).
● Specify the maximum number of received snapshots to retain for each source (see
"Changing the Maximum Number of Snapshots" on page 241).
Target Systems List
The Target Systems list displays the following information for each target system:
● Target - The IP address of the target system that the ETERNUS CS800 is configured
to send data to.
● Status - The replication status of the ETERNUS CS800. For a detailed description of
all possible replication statuses, see "Replication Overview" on page 182.
● Source IP - The IP address that is used to uniquely identify the source system to the
target.
● Encryption - The type of encryption used when sending replicated data to the target
system (None, 128-bit, or 256-bit).
● Original Data Size - The original, native size of data sent during replication or failback.
This value does not represent the amount of data actually sent over the network during
replication or failback because data is deduplicated and compressed before being sent.
● Actual Data Sent - The amount of data actually sent over the network during replication
or failback. This value is usually much less than the Original Data Size due to the
benefits of data deduplication and compression.
● Average Send Rate - The average send rate (in MB/s) of data sent over the network
during replication or failback (Actual Data Sent divided by the amount of time required
to complete replication or failback).
You can customize the appearance of the Target system list in the following ways:
● Click the top heading row of the list to collapse or expand the list.
● Click a column heading and select Sort Ascending or Sort Descending to sort the
rows in the table by that column.
To Next Page
Loading...
Need help?
General