Configuration Wizards AIS Connect
U41840-J-Z125-7-76 173
The setup of AISConnect consists of two tasks:
● Configuring and enabling the AISConnect service, which is done with the AISConnect
Wizard
● Registering the ETERNUS CS800 system with the Fujitsu Service Centre.
I
AISConnect uses the HTTP protocol to connect via the Internet to the Fujitsu
Support Centre. AISConnect allows to configure a HTTP proxy in order to connect
from a corporate network to the Internet. Please ask your network administrator
about what proxy and what proxy authentication to use.
I
To register the ETERNUS CS800 system with the Fujitsu Support Centre, please
place a service request at the Fujitsu Service Desk
http://ts.fujitsu.com/support/servicedesk.html
I
For more information about AIS Connect, see "AIS Connect" on page 331.
To begin the AISConnect wizard, on the Wizards menu, click AIS Connect.
Step 1: About
1. Read the information about the wizard (see Figure 113).
2. Click Next to continue.
I
At any time while using the wizard, you can click Previous to return to the previous
step.
To Next Page
Loading...
