EasyManua.ls Logo

Fujitsu ETERNUS CS800 S5 - Replication Overview; Send Settings & Cumulative Statistics

Fujitsu ETERNUS CS800 S5
634 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Replication Overview Home Page
182 U41840-J-Z125-7-76
Replication Overview
The Replication overview on the Home page (see Figure 120) displays the following infor-
mation about target and source replication activity:
"Send Settings & Cumulative Statistics"
"Receive Settings & Cumulative Statistics"
Send Settings & Cumulative Statistics
The Send Settings & Cumulative Statistics section displays statistics for all data sent
from the system since system installation or since Send cumulative replication statistics
were last cleared by clicking Clear Send on the Replication Actions page (see "Repli-
cation Performance" on page 386).
Target System - The IP address and replication status for each configured repli-
cation target (up to two). Click to specify a replication target (see "Replication
Configuration" on page 232).
Ready - (Green) The system is ready to perform replication.
In Progress - (Blue) A replication job is currently in progress.
Queued - (Blue) A replication job is queued and will continue when the system
is ready.
Manually Paused - (Yellow) Replication was manually paused. To resume
replication, click Resume.
System Paused - (Yellow) The system has automatically paused replication
due to a problem, for example, low disk space or a problem on the target
system.
To see more information about the problem that occurred, click Admin at the
top of the remote management console to view administration alerts (see
"Admin Alerts" on page 419). You may also need to view alerts on the target
system. In addition, make sure that the system is an allowed replication source
on the target system (see "Replication Configuration" on page 232).
Failed - (Red) A replication job was not completed.
Internal Error - (Red) An error occurred during replication.
Pause/Resume - The source system controls the replication pause behavior.
To manually pause replication between the source and target, click Pause on
the source system. To manually restart replication, click Resume on the source
system.

Table of Contents

Related product manuals