Fujitsu ETERNUS CS800 S5 - Other Important Information; FCC Class a Compliance Statement

FCC Class A Compliance Statement Important Information
24 U41840-J-Z125-7-76
● Ensure that no liquid enters the system. Ensure that the ventilation areas of the
device are clear.
Wipe the device casing with a dry cloth. If particularly dirty, use a cloth that has been
moistened in a mild domestic detergent and then carefully wrung out.
Other Important Information
Keep all documentation (documentation CD, poster; accompanying documentation if
delivered with special components) close to the device. All documentation must be included
if the equipment is passed on to a third party.
FCC Class A Compliance Statement
If there is an FCC statement on the device, then:
The following statement applies to the products covered in this manual, unless otherwise
specified herein. The statement for other products will appear in the accompanying
documentation.
W
WARNING!
This is a class A product. In a domestic environment this product may cause radio
interference in which case the user may be required to take adequate measures.
I
This equipment has been tested and found to comply with the limits for a "Class A"
digital device, pursuant to Part 15 of the FCC rules and meets all requirements of
the Canadian Interference-Causing Equipment Standard ICES-003 for digital
apparatus. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in strict
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no warranty that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of the
following measures:
● Reorient or relocate the receiving antenna.
● Increase the separation between equipment and the receiver.
● Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.