Handling Instructions for the Rack Installing the Rack
88 U41840-J-Z125-7-76
Figure 40: Adjusting the PRIMECENTER M1 19-inch rack
● Adjust the rack on all three axes (X,Y,Z) with the leveling feet. Use a spirit level to make
sure the rack is exactly level!
I
The horizontal orientation of the rack is required to ensure the pull-out functions of
the components mounted to the rack. The rack is set up properly, as a rule, when
the front panels of the mounted components add up to form a continuous vertical
line!
Installing the tilting protection
V
CAUTION!
● A tilting protection is mandatory as soon as one component is installed that can be
pulled out (e. g. for maintenance reasons) via teleskopic rails. The tilting protection
prevents the rack from tipping over.
● The tilting protection must make firm contact with the ground at the front.
● Make sure that no cables were cut off when installing and moving the tilting
protection.
Delivery Contents:
● Tilting protection (pre-assembled), consisting of two parts: slider (moving part) and
guide rail
● 2 x leveling foot
● Screw kit:
To Next Page
Loading...
