Fujitsu ETERNUS CS800 S5 - DX80 S2 Expansion Modules (Optionally, with Scale Model Only)

Storage Modules Hardware Description and Basic Operations
70 U41840-J-Z125-7-76
DX80 S2 Expansion Modules (optionally, with Scale model only)
ETERNUS DX80 S2 storage expansion modules are used in the ETERNUS CS800 S5
system to provide additional capacity (backup data storage). Each storage expansion
module contains 12 3.5-inch NL-SAS hard disk drives in the front (in the same way as the
storage base module) and two power supplies (with fans) in the rear.
Front View – Panel Features and Indicator
Figure 30: Front view of the Storage Expansion Module
Figure 31: LEDs on the front side of the Storage Expansion Module
Table 13: Status and meanings of each LED (in front of Storage Expansion Module)
LED name LED status Description
LINE LED green AC power is supplied to the module.
FAULT LED orange The module is in error status.
POWER LED green The module is operating normally.
FAULT LED
POWER LED
LINE LED