Replication Configuration Configuration
240 U41840-J-Z125-7-76
To add a replication source:
1. Under Source Systems click Add.
The Add Allowed Source window displays (see Figure 150).
Figure 150: Add Allowed Source
2. In the Source Hostname or IP box, enter the hostname or IP address of the system
that will send the replicated data to the ETERNUS CS800.
I
To use hostname format, you must specify at least one DNS IP address on the
Network page (see "Network" on page 286).
3. Click Apply.
Deleting a Replication Source
Delete a system from the list of replication sources if it will no longer send replicated data
to the ETERNUS CS800. After the source system is deleted, the ETERNUS CS800 will no
longer accept replicated data from that system.
To delete a replication source:
1. Under Source Systems, select one or more sources to delete.
2. Click Delete.
I
If a source system is deleted from the list, its contribution to the cumulative totals on
the Home page are not removed until you clear Receive statistics (see "Replication
Performance" on page 386).
To Next Page
Loading...
