Removal and Replacement Procedures for CRUs ETERNUS CS800 S4/S5 Hardware
U41840-J-Z125-7-76 513
Storage Subsystem
JX40 Storage Subsystem
Following chapter applies only to the ETERNUS CS800 S5 Entry.
Hard Disk Drive Removal and Installation
The Hard Disk Drive (HDD) used in the JX40 storage module is a 2.5’’ NL-SAS HDD with
7200 rpm.
Removing
1. Press the latch of the disk drive and open the lock lever (1) (see Figure 300).
2. Hold the lock lever and pull the disk drive partway.
3. Take the hard disk drive out of the bay while supporting its bottom (2).
Figure 300: Removing/Installing hard disk drive
Installing
1. Insert the HDD module into a drive bay and carefully push back as far as it will go.
2. Close the locking lever to lock the hard disk drive in place.
To Next Page
Loading...
