Configuration Notifications
U41840-J-Z125-7-76 325
2. Enter information about the destination:
I
If you are editing a destination, you cannot change the IP Address. So if you
need to change it for an existing destination, you have to replace this
destination by a new one.
● IP Address - (Optional) Cannot be modified, see note above.
● Name - Enter the name of the destination.
3. Select one or more traps to send to the destination:
● Failure - Sends failure traps.
● Warning - Sends warning traps.
● Informational - Sends informational traps.
● Available - Sends a trap when the system transitions from an unavailable to an
available state.
● Unavailable - Sends a trap when the system transitions from an available to an
unavailable state.
4. Click Apply.
Deleting a Destination
Delete an SNMP destination if you no longer want the ETERNUS CS800 to send traps to
the destination.
To delete a destination, select the destination and click Delete.
I
You can select multiple destinations to delete at once.
Community
The Community page allows you to manage SNMP community information for the
ETERNUS CS800. You can add, edit, and delete communities, and you can specify the
community access type.
To access the Community page, on the SNMP page, click the Community tab (see
Figure 202).
To Next Page
Loading...
