Replication Send Replication
352 U41840-J-Z125-7-76
cartridges are immediately available on the target systems. There is no need to recover the
share or partition to make the files or cartridges available. Disable Directory/File or
Cartridge Based Replication if you do not want to automatically replicate files or cartridges.
When you configure a share or partition for Directory/File or Cartridge Based Replication,
you must specify a Sync ID. The Sync ID associates the share or partition on the source
system with the share or partition on the target systems that will received the replicated
data. The Sync ID for the source share or partition must match the Sync ID for the target
share or partition.
To configure a source share or partition for Directory/File or Cartridge Based Replication:
1. If you have not already done so, configure the target share or partition on the target
system (see "Configuring a Target Share for Directory/File Based Replication" on
page 368 or "Configuring a Target Partition for Cartridge Based Replication" on
page 381).
2. On the source system, select the source share or partition and click Configure.
The Share or Partition Configure window displays (see Figure 214).
Figure 214: Share or Partition Configure Window
3. If it is not already selected, select the Enable Replication check box to enable repli-
cation for the share or partition.
4. Select the Enable Dir/File or Cartridge Based Replication to target check box to
enable Directory/File or Cartridge Based Replication for the share or partition.
Or clear the Enable Dir/File or Cartridge Based Replication to target check box to
disable Directory/File or Cartridge Based Replication for the share or partition.
5. Enter a Sync ID in the box.
The Sync ID is used to identify the target share or partition that will receive replicated
data from the source share or partition. The Sync ID must be identical to the Sync ID of
the target share or partition on the target system.
To Next Page
Loading...
