Initial Configuration, Connecting with the Network Running the Getting Started Wizard
U41840-J-Z125-7-76 121
● In addition, to enable communication with the target ETERNUS CS800 by means of the
gateway, you must add a second host route in the Routing Details section on the
source ETERNUS CS800.
In this example, you would specify a second set of routing details for the replication
interface on the source ETERNUS CS800:
● Destination - Use the IP address of the gateway (192.168.10.1).
● Dest Netmask - Use 255.255.255.255.
● Dest Gateway - Use the replication IP address of the source ETERNUS CS800
(192.168.10.100).
Figure 76: Interface Routing: Example 2
Backpanel Locations
The Backpanel Locations section at the bottom of the Network page displays a graphical
representation of the virtual Ethernet ports as they appear on the rear of the system.
The diagram indicates the current bonding configuration and connectivity status for all
Ethernet ports.
● Ports that are bonded together in an interface are shaded the same color.
● A green border indicates a port is connected to a network.
● A red border indicates a port is configured but is not connected to a network.
● Click Update Port View to update the information on the diagram.
Source ETERNUS CS800 Target ETERNUS CS800
192.168.10.x subnet
IP: 192.168.20.200
Replication IP:
192.168.10.100
Management/Data IP:
192.168.10.101
192.168.20.x subnet
Gateway IP:
192.168.10.1
192.168.20.1
To Next Page
Loading...
