Running the Getting Started Wizard Initial Configuration, Connecting with the Network
120 U41840-J-Z125-7-76
Figure 75: Interface Routing: Example 1
Example 2: Segments on the Same Subnet and Target on a Different Subnet
In the example below (see Figure 76), the ETERNUS CS800 has two segmented inter-
faces, one for data and management traffic, and one for replication traffic:
● The source ETERNUS CS800 management/data IP address and the source
ETERNUS CS800 replication IP address are on the same subnet (192.168.10.x). The
target ETERNUS CS800 IP address is on a different subnet (192.168.20.x)
● To make sure the replication segment is used when communicating with the target
ETERNUS CS800, you must add a network route in the Routing Details section on the
source ETERNUS CS800.
In this example, you would specify the following routing details for the replication
interface on the source ETERNUS CS800:
● Destination - Use the subnet of the target ETERNUS CS800 (192.168.20.0).
● Dest Netmask - Use 255.255.255.0.
● Dest Gateway - Use the IP address of the gateway (192.168.10.1).
Corporate Network
Host or Client
Default Gateway
10.30.24.1
Host or Client
10.30.24.x subnet
10.50.50.1 gateway
10.40.40.1 gateway
10.50.50.x subnet
10.20.20.x subnet
10.20.20.1 gateway
10.40.40.x subnet
To Next Page
Loading...
