Replication Wizard Configuration Wizards
164 U41840-J-Z125-7-76
b) (Optional) Select the Enable Directory/File based replication to target check box
to enable Directory/File Based Replication for the share, and then enter a Sync ID
in the box.
With Directory/File Based Replication, a file is automatically replicated when it is
closed or a period of time after it is modified. After replication, the replicated files are
immediately available on the target system.
The Sync ID is used to identify the target share that will receive replicated data from
the source share. The Sync ID must be identical to the Sync ID of the target share
on the target system.
c) Select the check box for each replication target you want to replicate the share to.
When the share is replicated, its data will be sent to all selected targets.
3. To configure the share to receive replicated data from another system, enter the
following information under Receive:
a) (Optional) Select the Enable Directory/File based replication to this System
check box to enable Directory/File Based Replication for the share, and then enter
a Sync ID in the box.
The Sync ID is used to identify the source share that will send replicated data to the
target share. The Sync ID
must be identical to the Sync ID of the source share on
the source system.
b) If you enabled Directory/File Based Replication, select an Access option:
● Locked - The share is not allowed to receive new Directory/File Based Repli-
cation data.
● Unlocked - The share is allowed to receive new Directory/File Based Repli-
cation data.
I
You cannot configure a share to both send and receive Directory/File Based
Replication data.
4. Click Apply.
5. (Optional) To configure additional shares for replication, repeat Steps 1–4.
6. Click Next to continue.
To Next Page
Loading...
