Replication Wizard Configuration Wizards
166 U41840-J-Z125-7-76
b) (Optional) Select the Enable Cartridge based replication to target check box to
enable Cartridge Based Replication for the partition, and then enter a Sync ID in
the box.
With Cartridge Based Replication, a cartridge is automatically replicated when it is
unmounted. After replication, the replicated cartridges are immediately available on
the target system.
The Sync ID is used to identify the target partition that will receive replicated data
from the source partition. The Sync ID must be identical to the Sync ID of the target
partition on the target system.
c) Select the check box for each replication target you want to replicate the partition
to. When the partition is replicated, its data will be sent to all selected targets.
3. To configure the partition to receive replicated data from another system, enter the
following information under Receive:
a) (Optional) Select the Enable Cartridge based replication to this System check
box to enable Cartridge Based Replication for the partition, and then enter a Sync
ID in the box.
The Sync ID is used to identify the source partition that will send replicated data to
the target partition. The Sync ID must be identical to the Sync ID of the source
partition on the source system.
b) If you enabled Cartridge Based Replication, select an Access option:
● Locked - The partition is not allowed to receive new Cartridge Based Repli-
cation data.
● Unlocked - The partition is allowed to receive new Cartridge Based Replication
data.
I
You cannot configure a partition to both send and receive Cartridge Based
Replication data.
4. Click Apply.
5. (Optional) To configure additional partitions for replication, repeat Steps 1–4.
6. Click Next to continue.
To Next Page
Loading...
