208 U41840-J-Z125-7-76
Figure 133: Add VTL Partition & Replication Settings Page
2. Under Partition Settings, enter information about the partition:
● Name - Enter the name of the VTL partition.
V
CAUTION!
Do not use an underscore ( _ ) in the name of the VTL partition.
● Library Model - Select the library model emulated by the partition. The library
model determines the inquiry string returned to the host by the ETERNUS CS800.
(The library model does not restrict the number of slots or drives in a partition
because library emulation is not a representation of a physical library.)
The following library models are available:
● Fujitsu CS-TL
● ADIC Scalar 100, ADIC Scalar i2000, or ADIC Scalar i500
● ADIC Pathlight VX
● Number of Storage Slots - Enter the number of storage slots in the partition (up to
9,000).
I
One I/E slot is created for each storage slot up to a maximum of 240 I/E
slots.
To Next Page
Loading...
