U41840-J-Z125-7-76 283
About Replication Throttling Statistics
Keep in mind the following information when observing actual network bandwidth usage
during a replication throttle event:
● During a replication throttle event, only outgoing replication data traffic is throttled, not
other outgoing traffic. Because of this, you may observe network usage to be higher
than the specified maximum bandwidth. Differences in the sampling time period may
also cause discrepancies between the specified maximum bandwidth and observed
traffic.
● If the ETERNUS CS800 is configured to use a bonded network interface for replication
traffic, load balancing is determined independently by the bonding mode selected for
the interface (see "Network" on page 286). Because of this, you may need to sum the
values for all slave devices in the bonded interface to calculate the overall outgoing
traffic rate.
● The replication throttle bandwidth maximum is specified in KB/s, MB/s, or GB/s, so
depending on the statistic or report you are observing, you may need to convert the
bandwidth maximum to Kb/s, Mb/s, or Gb/s in order to correctly compare it to the
observed values.
Scheduling E-mail Reports
The ETERNUS CS800 can automatically generate a report with system status data or with
configuration data and send it to all configured e-mail recipients.
I
For more information about e-mail reports and configuring e-mail recipients, see
"Email Reports" on page 318.
To configure a schedule for e-mail reports:
1. On the Scheduler Calendar page, add or edit an event in the Email Reports row (see
"Adding or Editing a Scheduled Event" on page 279).
2. In the Report Type drop-down box, select the type of e-mail report to schedule (Status
or Configuration).
3. (Optional) Specify when and how often the event reoccurs (see "Setting Recurrence for
a Scheduled Event" on page 285).
4. Click Apply.
To Next Page
Loading...
