300 U41840-J-Z125-7-76
To set the system date and time:
1. Select one of the following options:
● Network Time Protocol (NTP) Server - (Recommended) Select this option to
synchronize the ETERNUS CS800 with an NTP timeserver or pool. Then select or
specify a timeserver or pool.
● Select a Timeserver Pool - (Recommended) Select one of the well-known,
geographically-based NTP timeserver pools in the drop-down box.
I
To select a timeserver pool, you must first specify at least one DNS IP
address on the Network page (see "Network" on page 286). Otherwise,
you must specify the IP address of the timeserver pool.
● Specify a Timeserver or Pool - Type the name or IP address of the NTP server
or pool. (See http://support.ntp.org for information about publicly available NTP
servers)
To verify that the ETERNUS CS800 can communicate with the NTP server or pool,
click Test NTP.
● Manual Date & Time Settings - Select this option to manually set the system date
and time.
Specify the New System Date by clicking the calendar icon. Specify the New
System Time using the drop-down boxes.
2. In the Timezone drop-down box, select the time zone where the ETERNUS CS800 is
located.
3. Next to Time Format, select the format to use when displaying times (24 hours or 12
hours).
4. Click Apply.
To Next Page
Loading...
