306 U41840-J-Z125-7-76
To enable or disable SSL:
1. Under SSL Properties, select the Enable SSL option to enable SSL.
Or select the Disable SSL option to disable SSL.
I
The default setting is disabled.
2. Click Apply.
Server Authentication Warnings
Enabling SSL with the default Fujitsu Technology Solutions certificate allows you to
securely communicate with the ETERNUS CS800 Web-based interface using SSL
encryption. However, you may receive a warning from your Web browser stating that the
server you are attempting to connect to does not match the server embedded within the
certificate.
This is expected behavior because the default certificate can only be used for encryption
and not server authentication. You can install your own custom certificate in order to take
advantage of server authentication in addition to encrypted communication.
To suppress server authentication warnings for the default certificate:
● Internet Explorer - If a dialog box displays warning you of a possible certificate error,
add the IP address for the ETERNUS CS800 to the Trusted Sites list (Tools > Internet
Options > Security > Trusted Sites). If subsequent warning pages display along with
an option to close your Web browser or continue to the Web site, click Continue. This
suppresses the warnings until you restart your Web browser.
● Firefox - If the Secure Connection Failed dialog box displays, click the link at the
bottom of the dialog box and follow the instructions to add an exception for your
ETERNUS CS800.
Installing an SSL Certificate
You can purchase and install your own custom SSL certificate in order to take advantage
of server authentication in addition to encrypted communication on the ETERNUS CS800.
To install an SSL certificate:
1. Under Certificate, click New.
The Install New Certificate page displays (see Figure 188).
To Next Page
Loading...
