360 U41840-J-Z125-7-76
Figure 218: Recovered Share Name Page
2. (Optional) In the Recovered Share Name box, type a new name for the recovered
share. (The default name is the original share name.)
3. Click Apply.
4. If the ETERNUS CS800 is joined to a Windows workgroup, select the workgroup user
that will own the recovered share, and then click Apply.
The share is recovered on the target system. All data stored on the share at the time the
snapshot was saved is available. The original export protocol of the share (NFS or CIFS) is
retained in the recovery process.
I
After you recover a share, if you want to continue backing up data to the share, you
must remap your backup application to point to the target system instead of the
source system.
Performing a Failback for a Share
Perform a failback of a NAS share if a source system that was previously unavailable
becomes available again. When you failback a share, you select a received snapshot. The
ETERNUS CS800 copies the snapshot from the target system back to the source system.
You can then perform a recover operation to recreate the share on the source system just
as it was at the point in time when the snapshot was saved.
To Next Page
Loading...
