Removal and Replacement Procedures for CRUs ETERNUS CS800 S4/S5 Hardware
U41840-J-Z125-7-76 515
Figure 302: Removing a 3.5-inch HDD module
2. While pressing down on the locking button (1) fold up the lever (2).
I
Thereby, the HDD module is pushed out of its drive bay by about 1 cm and
disconnected from the SAS / SATA backplane.
3. Wait about 30 seconds to allow the hard disk drive to spin down.
4. Pull the HDD module completely out of its bay.
To Next Page
Loading...
