Installing the ETERNUS CS800 S5 Modules Installing the Components in the Rack
U41840-J-Z125-7-76 85
Position the support bracket at the corresponding height on the rear left support upright,
(place knob in the corresponding hole and secure it as described in the technical manual
for the rack in question.
Release the rails
Figure 42: Removing the Outer Telescopic Rail
Start with the left rail. To release the locking mechanism press the rear side of the toothed
levers together (1) and pull the hook simultaneously as far as it will go (2).
If the toothed levers are difficult to access you can use the unlocking tool to release it (see
delivery pack). Put the unlocking tool into the holes of the toothed levers.
Press the toothed levers together in the direction of arrow and pull simultaneously the hook
as far as it will go.
2
1
1
To Next Page
Loading...
