Fujitsu fi-8170

Setting Item Description Parameter(*1)/Value Factory Default
(*2)
- : No parameters/values
8:Check Blink
Speed
Specify an interval between each flash for
and [Information] in the [Settings
Menu] screen when is flashing on
the LCD.
0.5, 1.0, 1.5, 2.0, 2.5
(seconds)
2.0
9:LCD Scroll
Speed
Specify the speed at which the display is
horizontally scrolled.
The displayed item is scrolled horizontally
when the text does not fit in the LCD.
1:Fast
2:Normal
3:Slow
4:OFF
2:Normal
10:Low-speed
Feed Mode
Specify this to slow down the scanning
speed in order to protect the documents.
When performing a scan at a low
resolution (lower than 400 dpi), the scan
is performed at a slow speed regardless of
the resolution that is set. This setting is
effective for scanning long page
documents.
It can also be configured in the Software
Operation Panel.
1:Enable
2:Disable
2:Disable
11:ECO Mode When performing a scan at a low
resolution (300 dpi or less), the scan is
performed at a slow speed, which saves
the power consumption of the scanner.
When this is enabled, the scanning speed
is as follows:
● For fi-8190/fi-8290/fi-8170/fi-8270
Scanning is performed at the same
speed as performing a scan at 600 dpi.
● For fi-8150/fi-8250/fi-8150U/fi-8250U
Scanning is performed at the same
speed as performing a scan at 400 dpi.
It can also be configured in the Software
Operation Panel.
1:Enable
2:Disable
2:Disable
How to Use the Operator Panel [fi-8190/fi-8290/fi-8170/fi-8270]
163