Fujitsu fi-8170

Setting Item Description Parameter(*1)/Value Factory Default
(*2)
- : No parameters/values
12:Certification Displays logos. — —
13:Doc
Counting Mode
You can count the number of sheets
scanned.
— —
14:iMFF
Setting
Configure the setting to automatically
ignore certain patterns of overlapped
documents when the setting to detect
overlapped documents is enabled.
Note that you first need to specify [Check
Overlapping(Ultrasonic)] or [Check
Overlapping and Length] in the scanner
driver and Specifying a Method to Detect
Overlapped Documents [Multifeed] (page
378) on the Software Operation Panel
before setting this item.
By selecting [4:Clear pattern], you can
clear the overlapping patterns (length,
location) that were previously memorized
in Auto mode.
It can also be configured in the Software
Operation Panel.
1:Standard mode
2:Manual mode
3:Auto mode 1
4:Auto mode 2
5:Clear pattern
1:Standard mode
15:No. of
Paper Feed
Retries
Specify the number of feeding retries when
a document is not fed from the ADF paper
chute (feeder).
It can also be configured in the Software
Operation Panel.
1 to 12 (times) 3
16:Manual/
Continuous
Feed Setting
Configure the settings when manually
loading and scanning one sheet at a time.
When you scan by manually loading one
sheet at a time, you can specify the
waiting time (interval) for loading the
next document in the ADF paper chute
(feeder). This enables continuous scanning
as long as you load a document within the
specified time.
If the specified time is exceeded, the scan
is finished automatically.
It can also be configured in the Software
Operation Panel.
1:Enable
2:Disable
2:Disable
How to Use the Operator Panel [fi-8190/fi-8290/fi-8170/fi-8270]
164