8 Pick roller (× 2)
Gently wipe off any dirt or dust along the grooves as you rotate the roller manually, taking care not to
damage the roller surface. Make sure that it is wiped properly because black residue on the rollers will
affect the feeding performance.
9 Feed roller to be cleaned as you rotate the roller with the power turned on (× 2)
10 Eject roller to be cleaned as you rotate the roller with the power turned on (× 2)
The power must be turned on to rotate the feed/eject rollers for cleaning.
a Plug in the power cable and turn on the scanner.
For details, refer to How to Turn the Power ON (page 72).
● For fi-8190/fi-8290/fi-8170/fi-8270
When the [Ready] screen is displayed on the LCD, proceed to step b.
● For fi-8150/fi-8250/fi-8150U/fi-8250U
When "1" is displayed on the Function Number Display, proceed to step e.
b Press the [Menu] button.
The [Settings Menu] screen is displayed on the LCD.
c Press the [ ]/ [ ] button to select [3: Cleaning], then press the [Scan/Enter] button.
The [Cleaning] screen is displayed on the LCD.
d Press the [
]/ [ ] button to select [2: Roller Wipe], then press the [Scan/Enter] button.
A message is displayed on the LCD.
ATTENTION
Do not start scanning with an image scanning application during cleaning.
e Open the ADF.
For details, refer to How to Open the ADF (page 77).
When the ADF is open, it might close accidentally. Be careful not to get
your fingers caught.
f If you press the following button on the scanner, the feed rollers/eject rollers rotate a certain
amount of times simultaneously.
● For fi-8190/fi-8290/fi-8170/fi-8270
Daily Care
226
To Next Page
Loading...
