Fujitsu fi-8170

An Error (Error Code "U0:10", "U4:40" or "U5:4A") is Already Displayed in the LCD
After Power-on [fi-8190/fi-8290/fi-8170/fi-8270]
Check the following points
● Did you unlock the transport lock switch? [fi-8290/fi-8270] (page 312)
● Is the ADF closed firmly? (page 312)
● Is the print section (imprinter cover) closed firmly? (when the imprinter is installed) [fi-8190/fi-8170]
(page 312)
If the problem still persists, check each item in Before You Contact the Scanner Service Provider (page
330) first, then contact the distributor/dealer where you purchased this product. Refer to the contact
information in the Contact List if supplied with this product, or refer to the contact information in the
Contact for Inquiries section if provided in Safety Precautions supplied with this product, and then make an
inquiry.
● Did you unlock the transport lock switch? [fi-8290/fi-8270]
Solution
Turn off the scanner, and unlock the transport lock switch.
For details about how to turn off the scanner, refer to Turning the Power ON/OFF (page 72).
For details about unlocking the transport lock switch, refer to Transport Lock Error [fi-8290/fi-8270/fi-8250/
fi-8250U] (page 274).
● Is the ADF closed firmly?
Solution
Close the ADF firmly.
For details, refer to How to Close the ADF (page 78).
● Is the print section (imprinter cover) closed firmly? (when the imprinter is installed) [fi-8190/fi-8170]
Solution
Close the print section (imprinter cover) firmly.
For details, refer to the fi-819PRB Imprinter Operator's Guide.
Troubleshooting
312