Installing the expansion card
▶
Remove the expansion card from its protective packaging.
For more instructions regarding controller settings, see the
accompanying documentation.
▶
If applicable, install a slot bracket to the expansion card, see "Installing a
slot bracket" on page 172.
Figure 92: Installing an expansion card - example: riser module 3/4
▶
Carefully install the expansion card in the desired PCI slot and firmly press
down until it is completely fitted in the slot.
▶
If applicable, install SFP+ transceiver modules into the new expansion card,
see "Installing SFP+ transceiver modules" on page
174.
▶
If applicable, connect internal cables to the expansion card.
▶
If applicable, connect an FBU to the expansion card, see "Flash backup unit
(FBU)" on page 222.
Expansion cards and backup units
192 Upgrade and Maintenance Manual RX4770 M5
To Next Page
Loading...
