Upgrading the main memory
▶
Select an adequate memory configuration for "2 CPUs populated", see
"Basic information" on page
240.
▶
Install memory modules, see "Installing a memory module" on page 259.
At least you need to install one DIMM memory module per CPU as
minimum configuration.
Concluding steps
▶
Install the air duct on the top system board, see "Installing the CPU air duct"
on page
74.
▶
"Reassembling" on page 53.
▶
"Connecting the power cord (AC PSU)" on page 58.
▶
"Switching on the server" on page 59.
When the system is powered on after a CPU has been replaced or
upgraded, the Global Error indicator will start flashing with the message
CPU has been changed.
This only indicates that the CPU configuration has been altered. There
is no technical problem.
Proceed as follows:
●
Restart your server
.
●
As soon as the startup screen appears, press the [F2] function key to
enter the BIOS.
●
If a password is assigned, enter the password and press [Enter].
●
Select the Save & Exit menu.
●
Select Save Changes and Exit or Save Changes and Reset.
●
Verify that the Global Error indicator stops flashing.
▶
"Resuming BitLocker functionality" on page
108.
Processor (CPU)
280 Upgrade and Maintenance Manual RX4770 M5
To Next Page
Loading...
Need help?
General