Field Description
Possible values:
• Network Route (default value): Route to a network.
• Default Route : Is used if no other suitable route is avail-
able.
• Host Route : Route to a single host.
Destination IP Address /
Netmask
Only if Route Type Host Route or Network Route
Enter the IP address of the destination host.
If Route Type = Network Route also enter the netmask in the
second field. If no entry is made, your device uses a default net-
mask.
Interface If necessary, enter the interface to be used for this route.
Network Type Not for Route Type = Standard Route
Also select the network type.
Possible values:
• Direct (default value): You define another IP address for the
interface.
• Indirect: You define a gateway route.
Local IP Address Only for Network Type = Direct.
Enter the local IP address of your interface.
Gateway Only for Network Type = Indirect.
Enter the IP address of the gateway to which your device is to
forward the IP packets.
Metric Select the priority of the route.
The lower the value, the higher the priority of the route.
Value range from 0 to 15, The default value is 1.
Fields in the IP Routes Extended Route Parameters menu
Funkwerk Enterprise Communications GmbH
12 Routing
bintec W1002/W1002n/W2002/WIx040/WIx065 179
To Next Page
Loading...
Need help?
General
