Field Description
The function is activated with Enabled.
The function is enabled by default.
Create NAT Policy Specify whether Network Address Translation (NAT) is to be ac-
tivated.
The function is activated with Enabled.
The function is enabled by default.
Local IP Address Only for IP Address Mode = Static
Assign an IP address from your LAN to the PPT interface, which
is to be used as your device's internal source address.
Route Entries Only if IP Address Mode = Static
Define other routing entries for this PPTP partner.
Add a new entry with Add.
• Remote IP Address: IP address of the destination host or
destination network.
• Netmask: Netmask of Remote IP Address. If no entry is
made, your device uses a default netmask.
• Metric: The lower the value, the higher the priority of the
route (possible values 0... 15). The default value is 1.
The Advanced Settingsmenu consists of the following fields:
Fields in the menu Advanced Settings
Field Description
Block after Connection
Failure for
Enter the wait time in seconds before the device should try
again after an attempt to set up a connection has failed. The de-
fault value is 60.
Maximum Number of Di-
alup Retries
Enter the number of unsuccessful attempts to setup a connec-
tion before the interface is blocked.
Possible values are 0 to 100.
The default value is 5.
13 WAN Funkwerk Enterprise Communications GmbH
218 bintec W1002/W1002n/W2002/WIx040/WIx065
To Next Page
Loading...
Need help?
General
