FUTABA T10J - Page 66

67
Common function
In the initial state, the receiver voltage maximum and minimum values are displayed in the
transmitter. (Value until reset)
Display
① Select "RX-BATT" from the telemetry
screen with the Jog key.
② Open the setting screen by
pressing the Jog key.
① Select "MIN/MAX" from the RX-BATT
screen with the Jog key.
② Date reset by pressing the
Jog key for 1 second.
● A confirmation "beep"
sounds when complete.
Calling the setting screen
MIN/MAX reset
● Viewing the receiver voltage maximum and minimum values.
RX-BATT
(ALARM) (VIB) (LIMIT)
DN▶INH ▶OFF ▶ 6.0V
SPEECH▶ INH SW▶ NULL
0.0V
MIN/MAX=
0.0V / 0.0V
Do not stare at or set the transmitter setting screen while ying.
■Losing sight of the aircraft during ight is very dangerous.
■When you want to check the information during ight, call the telemetry screen before ight and have the screen
checked by someone other than the operator.
WARNING
Receiver voltage MAX
Receiver voltage display
Receiver voltage MIN
● Receiver
→
Transmitter.
The reception of the
signal from the receiver to
the transmitter is shown.
This does not affect ight.